Glass fiber reinforced plastic grill has become the main material used in the ground, but there are still many customers do not understand the use of installation. If improper installation is likely to reduce the life of the glass fiber reinforced plastic grid, damage to the cost of early. The following is for us to introduce the car wash room glass steel grille why to ensure a certain support.
We know that the use of carwash special glass steel grille makes component weight is reduced greatly, thus reducing the weight of the support structure, the installation requires the use of lifting equipment, economical and convenient.
The car wash glass steel grille when installing why to guarantee a certain support, because although the car wash glass steel grille board is a resilient board, but if the span is too large, long-term on the compression time is too long, the board will have degrees, so that the middle support board will not sink, on both sides of the board to be tilted, for a long time there will be a board fracture phenomenon.
Then the car wash house glass steel grating city how to design more reasonable? Flexibility and span are affecting the life of the board, so in the installation of the glass steel grille when the car is generally to ensure that the span is in the 30-35cm. The grid side supporting the support of at least 40mm, every 900mm ~ 1800mm centers should use the clip. At least 4 fixing clips are used for each grid, and the bottom of the connection between the grid and the grid is supported. Support Liang Kuan about 20 centimeters, trench span of about 30 centimeters, trench depth between 10--30, according to the actual situation of customers (clean up the cycle is short, shallow some; cycle length is deep.) The more the support beam, the smaller the span, the better the use of the grid.
The outer layer should be treated as corrosion protection. |
